Adafruit 128×64 OLED + Pi Zero case
Required Parts
| Qty. | Part | |
|---|---|---|
| 1 | × | sheet of card approx. A4 150gsm – 250gsm. |
| 4 | × | M2.5 8mm M/F standoff |
| 12 | × | M2.5 2mm hex nut |
| 4 | × | M2.5 bolt |
| 2 | × | 5mm diameter button caps |
| 1 | × | joystick cap (optional) |
The protruding thread of the standoff must be no less than 6mm.
Required Tools
- printer
to print out the supplied template - craft knife
for cutting-out the printed template - small screwdriver
for tightening bolts - 3D printer
for producing button caps
3D printed components
Most FFF/FDM printers should be capable of printing these parts. All models include generous tolerances; tolerances that may be too generous for better printers. If this is the case, you may need to design your own versions of these models.